July 5, 2013 3 Comments
Just got my Hutech clip in filter for D7000, here’s a unboxing post of the LPS-P2-N4 filter. LPS stands for Light Pollution Suppression I guess. Overlaying the glass is a special interference coating that rejects the unwanted wavelength from most sodium lamps, while passing the majority of nebula emission light.
A brochure of advertisement, including the spectrum of the filter
The filter packed inside a SD card box, rolled in bubble wrap
Clip the filter into the lens mount
Now it’s time to mount the lens. It’s said on their website that lens with greater than 8.7mm protrusion are not compatible. The Samyang 14mm 2.8 AE works pretty well with less than 8mm of protrusion. And it clears my biggest doubt on using wide angle lens with interference filter. Here’s 2 images taken with filter on, absence of any color vignetting seen on front mounted LPS.
The indoor shot showing distinctive spectrum from 2 fluorescent tube
And as expected, the AF 50 1.8D cannot be mounted because of an outstanding “Aperture Indexing Post” which transmit the maximum aperture mechanically. This is only required on old mechanical SLR like this one:
The Aperture Indexing Post couples with the small black tab in the bottom of the mount on camera side
Since DSLR communicate with the lens electronically, it makes no sense to preserve this protruding post. One way is to simply shave it down, but the rear element could be damaged in the process and it will leave dust inside. During my last repair with the plastic mount on my 18-105 DX lens, I’ve found out that the plastic ring hosting the “Aperture Indexing Post” could be disassembled independently from the mount. And it turned out to be the same with 50 1.8D lens.
Disassembled plastic ring from the metal mount
If you unscrew 3 black ones seen on the metal mounting ring and 2 on the side holding the electronic contacts, the black plastic ring would comes out easily. Then just screw the contact post back onto the metal ring. The lens could be used with the clip in filter easily.
The 180 2.8D telephoto lens was my biggest concern. The screws on the filter holder scraped the 2 corners of the plastic baffled tube. It seems the baffled tube can be disassembled, yet it would present a problem when light from the last element deep inside shines onto the metal mount leading to stray light. This lens is unlike the 50 1.8D where the last optical element is outside the mount, while 180 has the last one and aperture blades deep recessed inside the mount.
2 corners next to the electronic contact post are scraped on 180 2.8D
Star Field Test
The spectrum measured fits reasonably well with the advertisement. The spectrophotometer used only has 2nm FWHM, meaning that the graph below is the transmission of 5nm moving average.
Spectrum of LPS-P2 at 0 incident angle (Measuring interval 2nm)